A car accelerates from 20m/s to 30m/s in 10 sec. Find the cars acceleration using v=u+at

Answer:

[tex]U_g=58.86 J[/tex] or [tex]U_g=60 J[/tex]

Explanation:

Answer is attached. I do not know if you needed to use 9.81 or 10 for the acceleration due to gravity, so both solutions are attached.

Hi there!

We can begin by finding the final VERTICAL velocity of the ball.

Use the following kinematic equation: vf² = vi² + 2ad

The ball does not have any initial velocity in the vertical direction so:

vf² = 2ad

Plug in given values:

vf² = 2(9.81)(44) = 29.38 m/s

Find the TOTAL speed using the pythagorean theorem (involving both the horizontal velocity which remains the same and vertical velocity)

v = √(21²) + (29.38²) = 36.115 m/s

Answer:

40 to 80

Explanation:

A car's kinetic energy changes with the speed.  Cars going slower have less potential energy than cars going faster.

Answer:

it might be b maybe

Explanation:

Answer:

the equation :-

speed = distance ÷ time

Answer:

A rogue wave estimated at 18.3 meters (60 feet) in the Gulf Stream off of Charleston, South Carolina. At the time, surface winds were light at 15 knots.

Explanation:

Rogue, freak, or killer waves have been part of marine folklore for centuries, but have only been accepted as real by scientists over the past few decades.

Rogues, called 'extreme storm waves' by scientists, are those waves which are greater than twice the size of surrounding waves, are very unpredictable, and often come unexpectedly from directions other than prevailing wind and waves.

Most reports of extreme storm waves say they look like "walls of water." They are often steep-sided with unusually deep troughs.

Since these waves are uncommon, measurements and analysis of this phenomenon is extremely rare. Exactly how and when rogue waves form is still under investigation, but there are several known causes:

Constructive interference. Extreme waves often form because swells, while traveling across the ocean, do so at different speeds and directions. As these swells pass through one another, their crests, troughs, and lengths sometimes coincide and reinforce each other. This process can form unusually large, towering waves that quickly disappear. If the swells are travelling in the same direction, these mountainous waves may last for several minutes before subsiding.

Focusing of wave energy. When waves formed by a storm develop in a water current against the normal wave direction, an interaction can take place which results in a shortening of the wave frequency. This can cause the waves to dynamically join together, forming very big 'rogue' waves. The currents where these are sometimes seen are the Gulf Stream and Agulhas current. Extreme waves developed in this fashion tend to be longer lived.

Hope this helps, have a nice day/night! :D

On January 1st, 1995, the first accurate measurement of a rogue wave took place. It was captured by a laser detector on Statoil's Draupner oil drilling rig, which is situated 100 miles off the Norwegian coast.

Although rogue, freak, or killer waves have been mentioned in maritime legend for many years, scientists have only recently acknowledged their existence.

Scientists refer to these waves as "rogues," or "severe storm waves," since they are more than twice as large as the waves around them, very unpredictable, and frequently arrive from directions other than the prevailing wind and waves.

Extreme storm waves are typically described as looking like "walls of water" in reports. Frequently, they have steep sides and exceptionally deep valleys.

Measurements and analyses of this phenomenon are extremely rare because these waves are not common.

Learn more about rogue waves, refer the link:

https://brainly.com/question/14097449

#SPJ2

Answer:

6.7 km/h (C)

Explanation:

According to the table, the hiker's average speed for the entire hike would be 6.7 kilometers/hour.

The total distance covered by any object per unit of time is known as speed. It depends only on the magnitude of the moving object. The unit of speed is a meter/second. The generally considered unit for speed is a meter per second.

The total distance traveled by the hiker = 4 kilometers  + 6 kilometers + 4 kilometers west + 6 kilometers north

                                                                  = 20 kilometers

The total time is taken by the hiker = 45 min + 60 min + 30 min+ 45 min

                                                           = 180 min

                                                           =3 hours

The average speed of the hiker = 20 kilometers / 3 hours

                                                     = 6.7 kilometers / hours

Thus, the hiker's average speed for the entire hike would be 6.7 kilometers/hour.

To learn more about speed here, refer to the link;

brainly.com/question/7359669

#SPJ5

Hi there!

We can begin by summing forces acting on the load:

∑F = T - Mg (where g ≈10 m/s²)

ma = T - Mg

We can plug in the given values to solve:

ma = 2000 - 175(10)

175a = 250  

a = 250/175 = 1.43 m/s² UPWARDS

Answer:

a = 1.63 m/s^2

Explanation:

m = 176kg

Ft = 2000N

  2000 = 175 (9.8) +175(a)

    2000   = 1715 +175a

    -1715       -1715

285 = 175a

175     175

a = 1.63m/s^2  

Hi there!

We can begin by calculating the impulse exerted on the soccer ball:

I = Δp = mΔv

Plug in the given values:

I = 0.45 × 20 = 9 Ns

I = Ft, so:

I/t = F

9/0.1 = 90 N

Answer:Thus for n=1 number of electrons is 2 and for n=2 the number of electrons is 8. Hence the electronic configuration of the element X is 2,8,6 and its atomic number is 16. In the Modern Periodic Table, the element Sulphur has atomic number 16. So, the solution is that the element X is Sulphur and it is non metallic.

Answer:

Explanation:

Answer: Thus for n=1 number of electrons is 2 and for n=2 the number of electrons is 8. Hence the electronic configuration of the element X is 2,8,6 and its atomic number is 16. In the Modern Periodic Table, the element Sulphur has atomic number 16. So, the solution is that the element X is Sulphur and it is non metallic.

Answer:

at 2.5m

Explanation:

because 2.5m*4m is 10.0=10

To solve this, we must know each and every concept related to speed of efflux and its calculations. Therefore,  hole at 3m will have the greatest speed of efflux.

The velocity of outflow is the speed with which a liquid emerges from a hole cut at a certain height from bottom of the container within which the liquid is contained.

Mathematically, the formula for speed of efflux can be given as

speed of efflux =√2×g×h

g= acceleration due to gravity

h1=4- 1 =3m

h2=4-2=2m

h3=4-2.5=1.5m

h4=4-1.5=2.5

Since speed of efflux is directly proportional to height. More the vale of h more will be speed of efflux. So on calculations, hole at 3m will have the greatest speed of efflux.

Therefore,  hole at 3m will have the greatest speed of efflux.

To know more about  speed of efflux, here:

https://brainly.com/question/17087482

#SPJ2

Please find attached photograph for your answer.

Hope it helps.

Do comment if you have any query.

The initial velocity of the runner is 5.25 m/s.

You've probably seen that when there's a lot of traffic and there are more bikes blocking us, we tend to slow down the speed of our bikes.

Therefore, deceleration is defined as a reduction in speed as the body moves away from the beginning location. The opposite of acceleration is deceleration.

Given parameters:

Deceleration of the runner: a = 0.25 m/s².

Time interval: t = 5 second.

Final velocity: v = 4 m/s.

We have to find initial velocity of the runner: u = ?

From definition of deceleration, it can be written that:

deceleration = (initial velocity - final velocity) time interval

0.25 = (u -4)/5

u =  5.25 m/s.

Hence, initial velocity of the runner is 5.25 m/s.

Learn more about deceleration here:

https://brainly.com/question/4403243

#SPJ2

Answer:

They get air inside

Explanation:

bananas turn brown when air is inside

Answer:

The key benefits to this is the athlete thinks and reflects for themselves which is a vital part of the Learning Styles Model. This technique is most useful for more experienced athletes who like to have involvement and their own opinions about their performance.

Explanation:

[tex]▪▪▪▪▪▪▪▪▪▪▪▪▪  {\huge\mathfrak{Answer}}▪▪▪▪▪▪▪▪▪▪▪▪▪▪[/tex]

Solution is in attachment ~

I hope that you got what you were looking for, and if there's different data then go through the same procedure, using same formula with different values and you will get your answer ~

[tex]\mathrm{✌TeeNForeveR✌}[/tex]

Answer:1.9 × 10³⁰

Explanation:

Answer:

Electricity is the flow of electrons, because electrons pass from atom to atom.

Answer:

carbon dioxide

Explanation:

its common sense

Answer:

Gamma-rays are produced primarily by four different nuclear reactions; fusion, fission, alpha decay and gamma decay.

The type of process that can emit gamma - rays is nuclear reaction processes.

A nuclear reaction is a type of reaction in which two nuclei collide to produce one or more new nuclides and release energy in the process.

Examples of nuclear reactions;

Each of the nuclear reaction above can emit gamma - rays.

Thus, the type of process that can emit gamma - rays is nuclear reaction processes.

Learn more about nuclear reaction here: https://brainly.com/question/25387647

Explanation:

u=0, v=?, a=5m/s², t=8sec

So, by the formula,

v=u+at

v=0+5×8

v=40m/s.

hope this helps you .

The best example of physics in the body is the movement of an arm throwing a ball. The correct option is D.

Physics is the branch of science that studies the structure of matter and how the universe's fundamental constituents interact.

It investigates objects ranging from the very small to the entire universe using quantum mechanics and general relativity.

Physics is the natural science that investigates matter, its fundamental constituents, its motion and behavior in space and time, as well as the related entities of energy and force.

Physics is one of the most fundamental scientific disciplines, with the primary goal of understanding how the universe functions.

The movement of an arm throwing a ball is the best example of physics in the body.

Thus, the correct option is D.

For more details regarding physics, visit:

https://brainly.com/question/28600368

#SPJ2

Answer:

Explanation:

Ax= 20*sin37

Ay =20*cos37

Bx=15*cos40

By =  -15*sin40

Cx = -6*cos60

Cy = -6*sin60

Answer:

Ax = 12 cos 53

Ay = 12 sin 53

Bx = 15 cos 320 = 15 cos 40

By = 15 sin 320 = -15 sin 40

Cx = 6 cos 240 = -6 cos 60

Cy = 6 sin 240 = -6 sin 60

Answer:

"work against the force of the air in the tire"

The air in the tire provides a force opposing the force of the air provided by the plunger.