What is the mass of 4.02 mol Ba(NO2)2

Answer:

liquid, solid, gas

Explanation:

Solid, Liquid and gaseous

There are 5 states of matter

1.) Solid

2.) Liquid

3.) Gaseous

4.) Plasma

5.) Bose Einstein

the First three are main

Answer:

The molecular formula of a compound may be the empirical formula, or it may be a multiple of the empirical formula. For example, the molecular formula of butene, C4H8, shows that each freely existing molecule of butene contains four atoms of carbon and eight atoms of hydrogen. Its empirical formula is CH2.

Explanation:

Answer:

colloid

Explanation:

i think she making meth in her basement

Answer: Yes

Explanation:

Scientific theory can be defined as the solutions to the problems of the queries related to natural phenomena or it is the explanation for different aspects of the natural world. It is done with repeated testing procedure. To prove the facts of the theory, repeated experimental tests, and observations are done. The theories are tested under the controlled conditions of the experimental set up.

On the basis of the above description, we can say that the scientific investigations are done in the form of experimentation trials before proposing  a theory. The theory is tested and is not simply expected.

Answer: Yes, Clements compared ecological succession with the development of organisms. Yes, this theory was tested.

Explanation:

Answer:

It poisons animals, it coats reefs, and damages ecosystems.

Explanation:

It is the same principle with humans. If we drink oil ( the actual stuff from for example, Spindletop) we would get poisoned, and die. If we eat toothpaste over and over, we have to go to poison control so they can pump your stomach. If we drink cyanide, we will die. If we get poison in our food, we will either starve, try to fix it, or we get poisoned and die. If we were some fish, we might not be able to fix the water, so we starve, or we get poisoned.

It is the same lines as the animals, our pollution and oil floods our environment and we start to die.

Sponsered by: STAF

Save the Animals Foundation

Hope this helps!

I was kidding about the sponsership.

Answer:It is the same principle with humans. If we drink oil ( the actual stuff from for example, Spindletop) we would get poisoned, and die. If we eat toothpaste over and over, we have to go to poison control so they can pump your stomach. If we drink cyanide, we will die. If we get poison in our food, we will either starve, try to fix it, or we get poisoned and die. If we were some fish, we might not be able to fix the water, so we starve, or we get poisoned.It is the same lines as the animals, our pollution and oil floods our environment and we start to die.

Explanation:

Answer:

The answer is A. Construction. The production of raw materials for construction in factories is harmful for the environment due to CO2 emissions. The chemicals used in construction and the diesel used by construction vehicles are also harmful to the environment.

Explanation:

In an ecosystem , human activity which constitutes to air pollution is construction.

Ecosystem is defined as a system which consists of all living organisms and the physical components with which the living beings interact. The abiotic and biotic components are linked to each other through nutrient cycles and flow of energy.

Energy enters the ecosystem through the process of photosynthesis .Animals play an important role in transfer of energy as they feed on each other.As a result of this transfer of matter and energy takes place through the system .Living organisms also influence the quantity of biomass present.By decomposition of dead plants and animals by microbes nutrients are released back in to the soil.There are different types of ecosystems.

Learn more about ecosystem,here:

https://brainly.com/question/19267717

#SPJ6

Answer:

D: All of the above

Explanation:

It's all of the above, they are all pretty similar to the accurate answer.

Answer:

D

Explanation:

Answer:

B. stored energy

hope this helps!!

Answer:j

Explanation:im not stupid??

Answer:

2

Explanation:

student 2 is correct because the number of protons determines what element an atom is, and the number of valence electrons shows how the atom bonds and its reactivity.

Answer:

So if you divide the kg of butter and the cake that will be your answer and then you should have a fraction so the fraction would be 0.25 over 2 because you simplified it. 0.25/2

Explanation:

Answer:

Your lungs deliver oxygen and remove carbon dioxide from your blood in a process called gas exchange. Gas exchange happens in the capillaries surrounding the alveoli, where the oxygen that is breathed in enters the circulatory system and carbon dioxide in the blood is released to the lungs and then breathed out.

Answer:

Explanation

In the Bohr model of the atom, electrons travel in defined circular orbits around the nucleus. The orbits are labeled by an integer, the quantum number n. Electrons can jump from one orbit to another by emitting or absorbing energy.

Answer:

AgCN

Explanation:

Ag+C=N

Answer:

0.15066667

I tried, hope this helps :)

A few important ones........

Answer:

The rubber becomes brittle and can break in your hand. The explanation for why this happens concerns cross-linking bonds. Ultra-violet light from the sun provides the polymer molecules with the activation energy they need to be able to form more cross-links with other chains.

Answer:

8.4 m/s

Explanation:

Initial velocity of the object is 0 as it was at rest.

We need to find the object’s average velocity during the 3 second to 5 second.

We can see from the graph that from 3 s to 5 s, the graph is a straight line. If we take the slope we can find the average velocity during the 3 second to 5 second.

Displacement between 3 s to 5 s is :

D = 24.8 m - 8 m = 16.8 m

Time = 5 s - 3 s = 2 s

Now,

Average velocity,

[tex]v=\dfrac{\Delta y}{\Delta x}\\\\y=\dfrac{16.8\ m}{2\ m}\\\\y=8.4\ m[/tex]

So, the object’s average velocity during the 3 second to 5 second is 8.4 m/s.

Explanation:

When the forces acting on an object are balanced , there is no change in the object's motion.

A force acting on a resting object can cause the object to move.

On Earth, gravity pulls all objects toward the ground.

When a force acts in the opposite direction of another force, the forces counteract each other.

More than one force acting on a falling object can reduce its downward acceleration

Air resistance is caused by molecules of air pushing against a moving object

Answer:

To understand this first we must understand what is happening at the molecular level. When we heat any substance it changes its state of matter because its molecules get excited. For example, when we heat water it turns into gas so the molecules get excited. The hot air balloon will move faster if we add heat because the gas molecules will get excited and push against the balloon, making it faster. If we start removing heat, the balloon's acceleration will slow down because the molecules will get less excited.

Hot air balloons flies by means of it being lighter than air

The flame can be used to move the pilot to different directions by increasing the temperature of the air in the balloon and therefore, the volume, therefore, decreasing the density of the air which changes the elevation of the balloon to the appropriate elevation having winds moving in the desired direction

The principle by which the above process works is as follows:

According to Charles law, the volume of a mass of gas is directly proportional to its Kelvin temperature

V ∝ T

[tex]\dfrac{V_1}{T_1} = \dfrac{V_2}{T_2}[/tex]

[tex]V_2 = T_2 \times \dfrac{V_1}{T_1}[/tex]

[tex]Density, \rho = \dfrac{Mass, \ m}{Volume, \ V}[/tex]

Therefore, as the temperature is increased, the volume occupied the mass gas increases, and therefore, the density decreases

The principle on which the hot air balloon operates on is the principle that hot air is less dense than and therefore, rises above cool air

Therefore, the pilot of an hot air balloon heats up the air in the balloon to allow the balloon to rise and the pilot switches off the burner so that the air in the balloon cools and the balloon looses altitude

The mechanism of the hot air balloon does not have a steering, and therefore, the wind direction is used to steer the balloon

The direction of the wind is different at different altitude, such that by obtaining the direction of the wind at a given altitude, the pilot can raise or lower the balloon up or down to the altitude having the desired wind direction, by increasing the temperature of the air in the balloon by switching on the burner to go to a higher altitude, or by switching off the burner so the air in the balloon cools and the balloon loses some of its altitude to reach the wind going in the direction of the pilot

Learn more about hot air balloon here:

https://brainly.com/question/21890581

Answer:

I will assume that you mean

STP (Standard Temperature and Pressure)

21

3

≈

7 L

Explanation:

Since we know that

1 mole

of an ideal gas occupies

22.4 L

at

STP

then can establish the following relationships:

22.4 L

1 mole

or

1 mole

22.4 L

Knowing that, we can solve for the volume occupied by the helium gas,

0.35

mole

1

⋅

22.4 L

1

mole

=

7.84 L

as

7.84 L

−

−

−

−

−

The answer makes sense because if

1 mole

occupies

22.4 L

, then

0.35 moles

(roughly a third of the moles) will occupy a third of

22.4 L

(

if we round down 22.4 L to 21 L

)

−

−

−

21

3

≈

7 L

The volume occupied by 0.34 moles of Helium Gas is 7.62 L.

Any gas from the  group of rare gases that include helium, neon, argon, krypton, xenon, and usually radon and that exhibit great stability and extremely low reaction rates. — called also inert gas.

They have properties tending to an ideal gas.

It is asked that what volume will be occupied by  0.34 moles Helium Gas

The ideal gas equation is written as

PV = nRT

At STP , T = 273 K

P= 1atm

R = 0.0821 L(atm) mol⁻¹K⁻¹

Substituting the values

1 * V = 0.34 * 0.0821 * 273

V = 7.62 L

Therefore the volume occupied by 0.34 moles of Helium Gas is 7.62 L.

To know more about Noble Gas

https://brainly.com/question/2094768

#SPJ5

if an electron is passed from Ago B then Slides electrons which makes it electropositive i.e A+

According to the redox reactions , when an electron is transferred from A to B , B molecule has been reduced as it gains electrons.

Redox reactions comprise of two parts a reduced part and an oxidized part, which occur simultaneously . The part which is reduced gain electrons and hence there is a increase in oxidation state of the species.

While, the part which is oxidized looses electrons and hence there is a decrease in oxidation state of the species.During redox reactions, there is no net change in the number of electrons . Electrons which are given off in oxidation are used up in reduction.

The ion or molecule which accepts electrons is called as oxidizing agent while the ion or molecule which donates electrons is called as a reducing agent.

Learn more about redox reactions,here:

https://brainly.com/question/13293425

#SPJ2

Answer:

Explanation:

The density of a substance can be found by using the formula

[tex]density = \frac{mass}{volume} \\[/tex]

From the question

mass = 70 g

volume = 10 mL

We have

[tex]density = \frac{70}{10} \\ [/tex]

We have the final answer as

Hope this helps you

Answer:

there is no following so there isnt a answer

Explanation:

Answer:

Explanation:

The percentage error of a certain measurement can be found by using the formula

[tex]P(\%) = \frac{error}{actual \: \: number} \times 100\% \\ [/tex]

From the question

actual density = 0.7988 g/mL

error = 0.7988 - 0.7925 = 0.0063

So we have

[tex]P(\%) = \frac{0.0063}{0.7988} \times 100 \\ = 0.788683024...[/tex]

We have the final answer as

Hope this helps you

Answer:

A

Explanation:

An atom that is a different isotope of a given element would contain 6 protons, 7 neutrons, and 6 electrons. Therefore, option (A) is correct.

Isotopes are atoms of an element that contain the same atomic number as the original element but a different atomic mass. Isotopes of an element possess the same number of electrons and the number of protons but different numbers of neutrons in their respective nucleus.

For example, the isotopes of carbon are carbon-14, carbon-13, and carbon-12. Carbon-14 has a total of 8 neutrons, carbon-13 have a total of 7 neutrons, and carbon-12 has a total of 6 neutrons. So all the isotopes of carbon have different numbers of neutrons.

Given element has 6 protons, 6 neutrons, and 6 electrons. So the isotope of this element will have  6 protons, and 6 electrons but not 6 neutrons. Therefore, the element with 6 protons, 7 neutrons, and 6 electrons is the isotope of the given element.

Learn more about isotopes, here:

brainly.com/question/11680817

#SPJ2

Answer:

here is your answer

Explanation:

1. sodium sodium is very reactive metal

2. when it exposed in air it automatically form Na2O.

3. when when it put in water it reacts visoroustly and start burning on water.

( due to this it is called active element)